Zeinab M.

Process Engineer @Bantrel Co.

Worked as a process engineer in Conceptual Study, DBM and Feed for Diluent Recovery Unit project:\\\\nPerformed heat integration study (pinch analysis) to determine the best heat exchanger configuration for maximum energy saving in process plant. Designed Distillation Column, Stabilizer Column, Sour Water Stripper, performed reboiler selection, tower overhead and bottom hydraulics and column tray sizing rating for start-up and recycle mode. sized three- and two-phase Separators, Pressure Vessels and Storage Tanks. Carried out PSV and PVSV Sizing Calculations. Performed hydraulic calculations for single- and two-phase flow lines. Involved in process simulation of Sour Gas System. Prepared BFD, PFD, DPDT, P & ID and Line Designation Tables for process unit; participated in HAZOP review meetings, and closed HAZOP actions. Improved distillation column operability and fired heater efficiency by modifying column design and pre-warm up stripping vapors using fired heater flue gas. Reduced capital, operating and installation cost by optimizing the design of the feed pumps. Prepared Process Instrument and Equipment datasheets, tower internal datasheet, process package (H2S Scavenger, H2S Stripper and fuel gas system) datasheets.\\\\n• Worked as a process engineer in Feed and Detail Design for Storage Tank Addition Project:\\\\nPrepared PFD, P & ID, tie-in list, and LDT from first revision to IFC.\\\\n \\\\n\\\\n \\\\n \\\\n\\\\n \\\\n