Sagar Dudhal

About Sagar Dudhal

A dynamic professional with 15 Years of rich & valuable experience in Analog & Digital design & product Development. System DesignThermal Design, heat flow anlysisLeading high performance engineering team to execution,Periodicreviews to achive end product requirements abd end goals.Team Management, Team LeadingStrong experience in Motor driver design and development for BLDC, stepper PMSM & Servo Six step drive, FOC understanding, back emf and all Phase voltage and Current measurement.Strong experience in electronics hardware design like Analog circuit design, Digital circuit designAnalog fault protection for high speed response. Strong experience in PCB layout design, PCB troubleshooting, guide lining for PCB layout design by considering EMI-EMC & industrial standards, CAPA Owner Strong on experience on driving voltage & current controlled Brushed DC, Stepper Motor, BLDC motors & their drivers, Sensors, MOSFET, cables, thermal analysis, derating, Ethernet PHY & USB Hands on experience on DFMEA, PFMEA, WCCA, product architect design Sensor Interfaces Familiar with PDN (Power Delivery Network) Analysis, Experience in Power supply, Power budget, DC-DC converter, Buck, Boost Design, Wi-Fi & BluetoothFamiliar with FPGA, CPLD based design, Verilog, VHDL, Testbench, Synthesis Hands on experience in Industrial & Automotive Standards certification like ISO, AIS, CISPR, CE & UL Marking for EMI, EMC, Safety & Environmental validation. Effective collaboration with cross functional teams like Firmware, Software, Mechanical and Quality, Manufacturing, verification & Validation Hands on experience on process documentation (ECN, Engineering Change Management, DVP), Obsolescence Management & product development cycle & Design Impact Analysis Work exposure with global team like USA, UK, Europe, & ChinaHardware skills:• 8,16,32 Bit Microcontroller based system design & development, pin mapping using DAVE tool Cube- Mx Pin MUX• Mixed signal design, safety consideration• Requirement analysis, component selection & circuit simulation• Sensors, Linear power supply LDO, Buck, Boost topology, signal conditioning, protection circuits• Hardware Architecture, Embedded systems• Experience in communication protocols such, RS485, I2C, SPI, UART & CAN Analyzer ToolSoftware skills:• Familiar with Embedded “C” programming• Experience in using CAN,LIN, I2C, SPI, UART & RS485 protocol, CiA CAN in automation

Experience

1. Technical Advisor R & d Hardware

   Halliburton

   Apr 2026 — Present · IN

   Product Architecture design for Electro-Hydro-Mechanical Interfaces. SiC Mosfet based PMSM, BLDC motor driver design for 400V 600V. Thermal Analysis on board and on system level. Signal conditioning, System Design, subsystem design. Identifying potential system failures.Project Leading, Planning & Execution till concept protos to get delivered, Team Management

Education

• Shivaji University

  Master of Science (MSc), Electronics and Communications

  2007 — 2009

• Birla Institute of Technology and Science, Pilani

  Masters of Technology, Microelectronics

• Mudhoji College, PHALTAN

  Bachelor of Science - BSc, Electronics

Skills

• Schematic Capture
• Analog Circuit Design
• Calibration
• Electronic Control Systems
• Signal Processing
• Signal Conditioning
• Component Repair
• Test Validation
• Testing
• Power Supplies
• Pcb Design
• Interfacing
• Embedded C
• Circuit Breakers
• Debugging
• Digital Electronics
• Frequency Analysis
• Customer Support
• Isolation
• Digital Circuit Design
• Express Pcb
• Sensors
• Hardware Installation