Muhammed Thaha N C

About Muhammed Thaha N C

Excellent understanding of product development life cycle and processes management. Expert in power electronics, analog, digital & microcontroller designs. Skilled in power supply & DC-DC converters such as Buck, Boost, Buck-Boost, Flyback & LDO. Proficient in cost reduction of products through VAVE. Field failure analysis, troubleshooting and Root-Cause Countermeasures. Expert in DFMEA, reliability analysis, components stress analysis, derating analysis, worst case analysis, MTBF, and diagnostic coverage analysis for lighting and automotive applications. Proficient in components selection, preparation of Decision Analysis and Resolution (DAR), and bill of materials. Proficient in preparation & review of technical documents: requirement specification, customer experience matrix, hardware design document, design calculations, test plan, operation manual, product specification sheet, installation instruction sheet & troubleshooting guide. Proficient in PCB, schematics & simulation tools like Altium, Proteus, LTspice, TINA, and OrCAD. PCB prototyping and preparing relevant test reports. Master in soldering, able to solder any type of electronic components. Expert in module-level testing, hardware-firmware integration, and system-level testing. Knowledgeable in communication protocols such as I2C, SPI, CAN, and UART. Familiar with CCR & PWM LED dimming controls. Expert in EMI/EMC, surge, and environmental testing. NiCad & LiFePo battery capacity test and thermal management. Battery heater design and validation for cold weather application. Worked on BLDC motor drive used in autopilot steering control system. Expert in preparing project status reports and communicating with management/customers. Worked on project management tools such as Polarion, Doors, JIRA & VSTS. Strong technical team leadership and mentoring skills. Ability to coordinate multi-disciplined team. Excellent communication and interpersonal skills. Highly motivated, quick learner, and outstanding team player. Product design and validation testing as per various standards like CEC, IEC, ISO, UL & NFPA. Design Tools: Altium Designer, Cadence, Proteus, Dip Trace, LTspice, MP LAB & MikroC. Office Tools: MS Office, MS Project, MS Visio, Windchill & Oracle. Equipment Handled: Oscilloscope, Current Probe, Voltage Probe, Differential Probe, Power Analyzer, Frequency Converter, Function Generator, Digital Multimeter, Debuggers, Programmable AC/DC Power Supply, LCR Meter, Multi-Channel Data Acquisition Units & Climatic Chamber.

Experience

1. Electronics Development Engineer

   Siemens

   Aug 2023 — Present · Peachtree Corners, GA, US

   Design, develop, and test microprocessor-based embedded products for power electronics, integrating analog and digital circuitry for switching and fault detection.

Education

• University of Calicut

  Bachelor of Technology - BTech, Electrical and Electronics Engineering

  2011 — 2015